[SEL] New New Way Engine

[Skip Cleveland]

Does your engine have both pistons reaching top dead center at the same time 
(two crank pins @ 180 deg), or one at the top and the other at the bottom 
(one crank pin, 360 deg. crank) ?
Skip
----- Original Message ----- 
From: "Tim Christoff" <tchristoff at earthlink.net>
To: "The SEL email discussion list" <sel at lists.stationary-engine.com>
Sent: Sunday, February 08, 2009 6:55 PM
Subject: [SEL] New New Way Engine


>I finally got a New Way Twin today, actually, I bought it a few days ago
> but didn't get it until today.  It is a 6 to 7 hp with a nice cast brass
> tag.  The engine is complete and uses a buzz coil for ignition.  Anyone
> have any knowlege of how the wiring for this would work?  I can only find
> one place to connect the pos wire so I am wondering if just a single coil
> is all that is needed.  You can see a picture of it on Harry's page via
> this link.  http://www.smokstak.com/forum/showthread.php?t=57053
>
> Tim Christoff
> Basehor Kansas
>
>
>
>
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel


--------------------------------------------------------------------------------



No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.0.233 / Virus Database: 270.10.19/1939 - Release Date: 02/06/09 
17:28:00