[SEL] Old Iron Rebuild

Richard Strobel Richard_Strobel7 at msn.com
Wed Oct 1 17:02:34 PDT 2008


Good eye Dave...thanks much.
Rick


----- Original Message ----- 
From: "Dave Merchant" <kosh at ncweb.com>
To: "The SEL email discussion list" <sel at lists.stationary-engine.com>
Sent: Wednesday, October 01, 2008 4:26 PM
Subject: Re: [SEL] Old Iron Rebuild


> Looks like a grease cup on the outer pulley in 11.jpg...
>
> Dave Merchant
>
>
> At 05:15 PM 10/1/2008, you wrote:
> >Fine example of what went on the belt, Helen and Jim!!  Also looks like a
> >fine example of "loose wheel, tight wheel," in which if one wanted to 
> >stop
> >the pump, you would slide the belt over to the loose wheel.  We're just
> >finishing up a big F-M piston pump which has this same feature.
> >   One would think that the loose wheel would have a greaser in the hub 
> > and
> >not setscrews and the tight wheel would have setscrews which tightened on 
> >a
> >flat spot on the shaft.  I know a lot of these were cheated one way or
> >another to make tight wheels out of both.
> >
> >   So I guess I'm asking if there's any evidence of a greaser like a 
> > female
> >pipe thread on the loose wheel for a greaser?  Ours does have a collar 
> >which
> >holds the loose wheel on.  Both of ours have setscrews and evidence of 
> >being
> >cheated.
> >
> >And was there a special tool to move the belt from one pulley to the 
> >other?
> >
> >Comments from all welcome.
> >
> >RickinMt.
> >
> >
> > > http://www.oldengine.org/members/dolly/dando/dando.htm
> >
> >_______________________________________________
> >SEL mailing list
> >SEL at lists.stationary-engine.com
> >http://www.stationary-engine.com/mailman/listinfo/sel
>
> Dave Merchant
> kosh at nesys.com
> nesys_com at ameritech.net
> dmerchant at layerzero.com
>
> http://www.nesys.com
> http://www.nesys.org
> YouTube: SteamCrane
>
>
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel
> 



More information about the sel mailing list