[SEL] Head Gasket Material

[Edd Payne]

Patrick.Try this.It is not called manifoldite now.It is called manifold 
material sheet and is made by ACL.The # on it is PM762.
Bar code # 9315466018041  .The 9 at the front is smaller than the rest of 
the # so may not be used.
EDD PAYNE
PO Box 364 Gulgong N.S.W
Australia
2852
Phone:0263742387
edsengns at optusnet.com.au
edsengns
----- Original Message ----- 
From: "Russell Gilbert" <russell at ncable.com.au>
To: "The SEL email discussion list" <sel at lists.stationary-engine.com>
Sent: Thursday, May 29, 2008 7:57 AM
Subject: Re: [SEL] Head Gasket Material


> Patrick I recently purchased  good size sheet through Repco, was
> about 500x350mm, it was the re-enforced gear with the thin metal
> sheet through the middle of the gasket material. Try a local store
> and see how you go.
> Russell
>
> At 08:31 PM 28/05/2008, you wrote:
>>Can anyone recommend a product that is good for making head gaskets and
>>where I could get some in Oz?
>>I have previously used a product called 'Manifoldite' but it seems to not 
>>be
>>available anymore :(
>>
>>Patrick M Livingstone
>>Leichhardt NSW
>>http://www.oldengine.org/members/pml/Index.html
>>
>>
>>_______________________________________________
>>SEL mailing list
>>SEL at lists.stationary-engine.com
>>http://www.stationary-engine.com/mailman/listinfo/sel
>
> Russell Gilbert
> Sunny Sunraysia
> russell at ncable.com.au
> http://community.webshots.com/user/russellsrelics
>
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel
>