[SEL] white metal for bearings (Babbitt)
Germoamer at aol.com
Germoamer at aol.com
Wed Jul 9 14:08:51 PDT 2008
In a message dated 7/8/2008 10:31:47 PM Eastern Standard Time,
plowe at exemail.com.au writes:
1. What is the tolerance between the crankshaft and the bearing ID. The
crankshaft is 1 1/2" dia. and the bearing is about 4 1/2" long. How many
thou. do I allow.?
Peter,
I have always heard a good rule of thumb is .001/inch of diameter for mains
and rod bearings on the old engines.
Tom Schmutz
Concord, Va.
germaoamer at AOL.com
**************Get the scoop on last night's hottest shows and the live music
scene in your area - Check out TourTracker.com!
(http://www.tourtracker.com?NCID=aolmus00050000000112)
More information about the sel
mailing list