[SEL] Crankshaft extending

[Judge Tommy Turner]

George,
    Did they cut it off so that the flywheel won't fit back on the 
shaft?  If not, is there a reason you want it longer (to mount a 
pulley?).  The reason I ask is that many engine builders didn't extend 
the c/s much beyond the hubs.

Tommy Turner
Magnolia, KY



Best, George wrote:

>I've got an engine where someone took a hacksaw and shortened the
>crankshaft for some reason.  Maybe it stuck out too far and they didn't
>want to use a belt pulley on it.
>
>I'm wondering if it is feasible to extend the crankshaft, or should I
>find replacement crankshaft instead?
>
>What I'm thinking is that I could put the crankshaft on the lathe and
>true up where they cut the shaft.  Then center bore the shaft.
>Make an extention piece with a stub to fit the bored hole in the
>crankshaft.
>Press the extention piece in.
>Weld the seam.
>Then clean up the joint in the lathe.
>
>Does this sound like a feasible way to fix the crankshaft?
>
>
>This message and any attachments are intended only for the use of the addressee and may contain information that is privileged and confidential. If the reader of the message is not the intended recipient or an authorized representative of the intended recipient, you are hereby notified that any dissemination of this communication is strictly prohibited. If you have received this communication in error, please notify us immediately by e-mail and delete the message and any attachments from your system.
>
>_______________________________________________
>SEL mailing list
>SEL at lists.stationary-engine.com
>http://www.stationary-engine.com/mailman/listinfo/sel
>
>
>
>  
>