[SEL] Need Advice on Cast Part Repair

[Paul Maples]

Joe you are probably correct in suggesting that I leave it alone but since I 
have went this far I thought if there was a fairly simple way of getting to 
it back to it's original dimension I would, otherwise I will leave it alone.

Paul

----- Original Message ----- 
From: "Joseph L Betz" <jlb94 at juno.com>
To: <sel at lists.stationary-engine.com>
Sent: Thursday, January 04, 2007 8:41 PM
Subject: Re: [SEL] Need Advice on Cast Part Repair


> Hi PAul.
>
> Maybe I'm wrong but the worn area I see doesn't seem to be that bad.
>
> Is it causing a problem with pumping ?
>
> If not, I would leave it alone.
>
> Not being a great welder - but, a pretty good brazer, I would braze it
> with OxyAcetyline
> and grind it to size.
>
> Just my opinion.
>