[SEL] Casting Demo

[Rick Rowlands]

I thought they were making iron castings over there.  What would the 
aluminum flywheel be used for?

Rick

----- Original Message ----- 
From: "Ed stoller" <edstoller at earthlink.net>
To: "stationary-engine at atis.net" <sel at lists.stationary-engine.com>
Cc: <stationary-engine at oldengine.org>
Sent: Friday, September 08, 2006 1:47 PM
Subject: [SEL] Casting Demo


Just prior to the Portland, Ind. Show, the Glassford family hosted a 
demonstration of making some castings. I posted some pictures on my site 
below. The main part for me was making the molds of sand. I had never seen 
this before and was too busy watching and listening to take pictures. I want 
to thank the whole family, especially the little grand daughter serving 
cookies.

John can use old Briggs and I assume Kohler and Tecumseh blocks for the cast 
iron. I don't think he would turn down scrap aluminum and brass either. I 
want to save mine to take to them next year.

Thank you all at Grandpa's Casting Co. 1-888-271-6696 
http://home.earthlink.net/~edstoller/id18.html



Ed Stoller
New Fairfield, CT
http://home.earthlink.net/~edstoller/
_______________________________________________
SEL mailing list
SEL at lists.stationary-engine.com
http://www.stationary-engine.com/mailman/listinfo/sel