[SEL] [Fwd: Mery castings] again

[R & M Ingold]

I dont think I will ever take on another of those! <G> Lots of really 
accurate stuff and you need a decent size mill too.
Reg & Marg Ingold.
Newcastle, NSW, Australia.
randmingold at hotkey.net.au
http://www.oldengine.org/members/randmingold

----- Original Message ----- 
From: "Steve Gray" <segray at mlode.com>
To: "The SEL email discussion list" <sel at lists.stationary-engine.com>
Sent: Thursday, May 25, 2006 6:07 AM
Subject: [SEL] [Fwd: Mery castings] again


> Didn't see Michael's message come through so we'll try it this way...
>
> -- 
> Steve Gray
> Member EDGE & TA, Br. 13 & 27
> Sonora, California USA
> e-mail:   segray at mlode.com
> Home page:   http://www.oldengineshed.com
>
>
>
>
> Michael Bancroft wrote:
>
> I have a set of Mery Castings that it does not look like I will get to in 
> this life time.  Set #107 unmachined except for flywheel that was done by 
> the factory.  Any market for this project?
>
> Mbancroft@ hughes.net
>
>


--------------------------------------------------------------------------------


> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel
>