[SEL] Re: Falk piston pattern update

Rick Rowlands jrrowlands at neo.rr.com
Thu Mar 9 03:28:54 PST 2006


Dave,

Mounting them on boards would make things a bit easier on me.  I have a 
couple of small flask sizes and I'll give you the dimenstions to make the 
board.

Rick

----- Original Message ----- 
From: "Dave Otto" <dotto at velocitus.net>
To: "'The SEL email discussion list'" <sel at lists.stationary-engine.com>
Sent: Wednesday, March 08, 2006 11:00 PM
Subject: RE: [SEL] Re: Falk piston pattern update


> Hi all
>
> I posted some pictures of the rocker arm patterns I have been working on. 
> I
> ordered a tapered end mill with a 5deg taper to generate the required 
> draft.
> This has worked well; I originally was going to cut them straight and then
> sand the draft by hand. I quickly realized that wasn't going to work. The
> tooling holes will be plugged before sending them to the foundry. The 
> proper
> letters will also be applied. I will try to post some pictures of the 
> finial
> product be for they go to he foundry.
>
> Rick, if you check out the pictures can you tell me if you will be able to
> cast these loose? If needed I think I can cut them in half in the mill 
> using
> a very thin jewelers saw, and mount them one a board.
>
> Here is the link; http://community.webshots.com/album/548384271MxhLtk
>
> Dave
>
> Dave Otto
> Boise, Idaho
> USA
> dotto at velocitus.net
> http://community.webshots.com/user/otto1960
>
>
>
>
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel 




More information about the sel mailing list