[SEL] Cushman R-12 Information Needed
Jerry Evans
jerrye at databak.co.za
Wed Jun 21 02:54:13 PDT 2006
At 06:00 PM 16/06/2006, you wrote:
>Message: 3
>Date: Thu, 15 Jun 2006 15:38:26 EDT
>From: FRM8198 at aol.com
>Subject: Re: [SEL] Cushman R-12 Information Needed
>
>Jerry,
>
>Thanks for the reponse.
>I made the assumption that my engine is a Cushman R12 based on the Massey
>Harris Model R Engines Instruction and Parts book that you so kindly sent
>me.
>I am going by the size of the flywheels (2" x 12"). The information is on
>Page 12 - part number 29-113. The reason I was asking about the serial
>number
>is that two different types of of mixers were used depending on whether the
>engine was built before and after serial number 66,000 (See Page 15 - part
>number A19-481 or A16-481). Perhaps either one will work as I don't have
>any
>mixer on the engine. It requires the screw in head type mixer and not
>the slip
>in type mixer.
>
>Francis Maciel
>Santa Maria, CA
Hi Francis,
Did you ever find out if the engine number is stamped anywhere
else on the casting? I also posted this question to SEL a few months ago
but got no response. If you do find out please let me know as I have 2
others (Cushmans) without plates that I would like to find out about.
Keep the revs up (or down)
Jerry Evans
Near Johannesburg in Sunny South Africa.
Tel. (016) 365-5787 or 083 283 7191
Visit our website for old engines in South Africa.
www.oldengine.org/members/evans
---
[This E-mail scanned for viruses by Declude Virus]
More information about the sel
mailing list