[SEL] 2 1/2 HP. IHC

[R and E Freeman]

My experience is it might be hard to get a sleeve that long. I have put in
two sections and positioned them so's the rings don't go over the join.I
machine them so's there is around 4 thou interference. Run one all day today
without a problem.
Ray Freeman
Perth 
Western Australia


-----Original Message-----
From: sel-bounces at lists.stationary-engine.com
[mailto:sel-bounces at lists.stationary-engine.com] On Behalf Of Jim O'Hagan
Sent: Monday, 5 June 2006 12:31 PM
To: 'The SEL email discussion list'
Subject: [SEL] 2 1/2 HP. IHC

Hi,I need some help .I'm working a 2&1/2 horse Famous that needs to be
sleeved. The original bore is 4" x11".Does any one know of a source for a
thin wall cast sleeve? Another alternative would be a useable
cylinder/hopper. I guess a shorter sleeve would work as long as the rings
didn't go past the end of the sleeve. Any one have success trying that .The
indexing of the boring bar would have to be right on. Thanks for any
information or ideas. Jimmy O'Hagan, Novato, Ca.  415 892 0236

Jim O'Hagan

 

_______________________________________________
SEL mailing list
SEL at lists.stationary-engine.com
http://www.stationary-engine.com/mailman/listinfo/sel