[SEL] bore and sleave an engine question

[Craig Prucha]

Hi Curt,

All I can say to this statement below in your reply to Bill is that you are my hero if you can machine a raw piston casting in 3 to 4 hours. Take care...

Craig



On Thu, 06 Jul 2006 09:53:08 -0400, Curt wrote:
> Bill,
> Like I said yesterday there are a lot of opinions on boring vs.
> sleeving... (snip, snip...)
>
>... If you own or have
> access to machineshop equipment, the piston machining process is 3
> or 4 hours tops...(snip, snip...)
>
>Curt Holland Gastonia, NC
>
>