[SEL] Re: 7 Economy

Keith Kinney kkinney at herculesengines.com
Fri Jan 13 22:15:53 PST 2006


I've had a similar situation on a couple of my Hercules built 
engines.  What I did was to stand the blade upright in a vice and 
built up braze on the end.  Then I ground it to shape.  I've built up 
as much as 1/2" and it has worked fine.
Keith


At 10:43 PM 1/13/2006, you wrote:
>Thanks Glenn.  It sounds like Hit n Miss sent me the short one.  I think
>I will cut it in the middle and splice a piece in to make it longer.
>Thanks again for your help.
>
>Ron Haskell
>rdhaskell at juno.com
>Riverside, California
>USA
>http://albums.photo.epson.com/j/AlbumList?u=3009370&f=0
>
>On Fri, 13 Jan 2006 21:07:36 -0600 "Glenn A Karch" <glenn.karch at gte.net>
>writes:
> > Ron,
> >
> > The detent blade is adjustable back and forth, but I assume you are
> > out of
> > adjustment room.  There are two different blades - one for the small
> > engines
> > and another for all the rest.  There are also two different blade
> > holders.
> > One has one bolt to hold the blade on and the other has two bolts.
> > Each
> > takes a different blade.  Get a piece of 3/16" x 3/4" strap iron and
> > make
> > one or weld an extension on the one you have.
> >
> > Glenn
> >
> > Glenn Karch
> > Haubstadt, IN, USA
> > Hercules Historian
> >
>_______________________________________________
>SEL mailing list
>SEL at lists.stationary-engine.com
>http://www.stationary-engine.com/mailman/listinfo/sel




More information about the sel mailing list