[SEL] Famous cooling screen mount

[Arnie Fero]

Hi Curt,

That's all useful as far as it goes, but unless you also have the details
on which side of the square nuts was uppermost on those carriage bolts,
poor ol' Mike is doomed.  I sure do hope you kept notes...

See ya,  Arnie

On Tue, 4 Apr 2006, Curt wrote:

> Depending on the size tank you are using I may have the parts used to
> mount the screen cooler to the cart rails. The IHC cart I took apart had
> a frame of angle iron (about 1 1/4" to 1") sawn and formed to make a
> square frame. This frame was mounted to the engine cart via carriage
> bolts. As I recall there are tabs on the front and back of the frame
> that the rods pass thru coming down from the pipe brackets on the screen
> cooler. There was no wood left on my cart when I got it, so I can't tell
> you if there were thin wood board between the cart rails and this square
> frame, or if the square frame was mounted directly on the channels.
> Perhaps someone can add that piece of information.
> The cross irons on IHC saw carts allow different width spacing for
> different HP engines. The cart was originally set up as a 6HP but I
> reconfigured as a 8HP and therefore the original 6HP screen cooler mount
> was not appropriate for the engine. I will measure and take a few
> pictures of what I have if you are interested in these 6HP parts.