[SEL] just off the subject of Cold Cut

[Arthur Buchanan]

Gene: I was in a shop yesterday and a welder was cutting 2x1/4 x3'-strips 
with the milwaque. eleminates a lot of torch work.



---- Original Message ----- 
From: "kgw" <gwaugh at wowway.com>
To: "The SEL email discussion list" <sel at lists.stationary-engine.com>
Sent: Tuesday, September 20, 2005 8:33 AM
Subject: Re: [SEL] just off the subject of Cold Cut


>  Peter, the Milwaukee circular metal saw I have would be ideal for this...
>
> http://tinyurl.com/cd26l
>
> Someone else, I think perhaps Makita, makes a similar machine.  You would 
> be able to cut in either direction, either with or against the 
> corrugations.
>
> Gene
>
> Elgin, illinois USA*
> *
> peter ogborne wrote:
>
>> What is a good method to cut corrugated iron sheet ,i.e. down the 
>> corrugations?
>> Abrasive disc makes too much bloody noise, hand nibbler so bloody slow, 
>> aviation snips not bad ,but not ideal either!
>> Peter Ogborne
>> Little Grove ,Albany
>> West Australia
>> ''Heart of the Rainbow Coast ''
>> jopeter at omninet.net.au
>>
>> _______________________________________________
>> SEL mailing list
>> SEL at lists.stationary-engine.com
>> http://www.stationary-engine.com/mailman/listinfo/sel
>>
>>
>>
>
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel