[SEL] Fairbanks Morse ZD Frustrations

[Germoamer at aol.com]

In a message dated 9/18/2005 10:13:09 PM Eastern Daylight Time, 
FRM8198 at aol.com writes:

<< First of all, I decided to find TDC and then determine where the  flywheel 
 magneto timing mark should be.  Luckily, I have  another running engine and 
I was 
 able to get the correct  dimensions.
 Yes, the flywheel magneto timing mark on the replacement flywheel  was off 
by 
 90 degrees clockwise.  >>


Way to go Francis!  When all else fails sit back, figure out what the problem 
is, and then resolve it!  I always go and read the directions after I have 
tried it without reading them!  HA!

Glad you got it going.