[SEL] Cold Cut Chop Saw

[ED]

Paul,

Did that carbide blade have 40 or 60 teeth? I have used such on a table saw
to cut aluminum picture frames.

Ed Stoller
New Fairfield, CT
http://home.earthlink.net/~edstoller/


----- Original Message ----- 
From: <EnginePaul at aol.com>
To: <sel at lists.stationary-engine.com>
Sent: Sunday, September 18, 2005 1:19 AM
Subject: Re: [SEL] Cold Cut Chop Saw


>
> Not sure if this is  relevant, but I've cut 1/4" aluminum using a regular
> carbide blade in a  Skillsaw. Used to cut aluminum letterpress plate in a
print
> shop I worked at  with a special table saw.
> Paul in S.F.
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel
>