[SEL] New Way piston is free

[Richard Strobel]

  Don't get no better than this gang.  Used the grease gun method but did 
not heed Rob and Kelley's warning:

 "You need to block off all holes in the cylinder where grease can escape. 
The valves should be in place, exhaust ports covered, and access holes 
covered." <vbg>

I was too focused on pouring the french fry grease into the funnel and only 
sensed something was wrong when all the stray dogs showed up :-))))...yea 
the exhaust valve was open.  Should have put the air hose to the spark plug 
hole first  .see:

http://community.webshots.com/photo/471752277/476985624PhFWAg

Plugged the exhaust hole and after a couple pumps..she moved.:

http://community.webshots.com/photo/476983859/476983859hBBJTS

and a little more:

http://community.webshots.com/photo/476983930/476983930bgPBeF

  I didn't go any farther as now I can reach up and feel the cylinder, and 
there is a lot of gunk on the cylinder wall, but now I can fold open the 
engine case and disconnect the rod and get 'er in the electrolysis tank. 
Install piston stop also.

  Not only is this hobby educational...it is also VERY SELF-ENTERTAINING :-)

later
RickinMt