[SEL] Piston wall woes

[cgandree at mchsi.com]

Thanks Brock was hoping that was the issue.
Curt


> G,day Curt
> i think it will  be fine after a bit of running the grove will fill with 
> carbon and seal up i have a few engines with same problem it does not worry 
> them
> brock
> ----- Original Message ----- 
> From: <cgandree at mchsi.com>
> To: "SEL Lists" <sel at lists.stationary-engine.com>
> Sent: Tuesday, October 11, 2005 9:05 PM
> Subject: [SEL] Piston wall woes
> 
> 
> > Looking for some help with my Sandwich 1 1/2 restoration.  Discovered 
> > after
> > attempting to hone out the piston wall that there is a slight indentation 
> > on
> > one side caused by a loose rist pin in the engines previous life.  After 
> > some
> > more honing the indentation seems to be somewhat less but now I fear 
> > possible
> > blow-by if I continue to hone more.  How far should one go?
> > thankyou in advance,
> > Curt Andree
> > _______________________________________________
> > SEL mailing list
> > SEL at lists.stationary-engine.com
> > http://www.stationary-engine.com/mailman/listinfo/sel
> > 
> 
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel