[SEL] Friend piston questions

[Tod Engine]

I was wondering if the piston casting that I am making for Curt would be the 
correct dimensions for you.  If so you can get one from him and machine it 
to fit.  If not then maybe I could make something up that would work.


Rick

----- Original Message ----- 
From: "Richard Strobel" <Richard_Strobel7 at msn.com>
To: "The SEL email discussion list" <sel at lists.stationary-engine.com>
Sent: Wednesday, May 04, 2005 9:25 PM
Subject: Re: [SEL] Friend piston questions


> Mike... is the old one buggered up so bad that Rowlands can't duplicate 
> it?
>
>
> Good Luck
> RickinMt.
>
>
>> > According to Ed at Hit & Miss, an IHC LB 3-5 piston is 4 inches with a
>> > wrist pin hole that would work but the distance from the top of the 
>> > piston
>> > to the top of the wrist pin is close to 2 inches.  Would an extra 0.5
>> > inches of compression stroke be too much for a headless engine to 
>> > handle?
>> >
>> > Thanks for the help,
>> > Mike
>>
>>
>> _______________________________________________
>> SEL mailing list
>> SEL at lists.stationary-engine.com
>> http://www.stationary-engine.com/mailman/listinfo/sel
>>
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel
>