[SEL] IHC logo pattern

[Richard Strobel]

'preciate it Bill.  I'll look and see if I have any good logo's

later,
RickinMt.


----- Original Message ----- 
From: "Bill Calvert" <wdcalvert at calvertmcbride.com>
To: "'The SEL email discussion list'" <sel at lists.stationary-engine.com>
Sent: Friday, June 17, 2005 2:01 PM
Subject: RE: [SEL] IHC logo pattern


> Richard
> 
> If any one has an item that has a clean logo on it, a clay dam could be
> put around the logo and rubber casting compound poured into the area.
> Then wax patterns could be made and attached to almost anything.
> 
> Bill 
> 
> -----Original Message-----
> From: Richard Strobel [mailto:Richard_Strobel7 at msn.com] 
> Sent: Friday, June 17, 2005 12:42 PM
> To: sel
> Subject: [SEL] IHC logo pattern
> 
>   G'day all;
> 
>   Will be sending some muffler castings to Rick soon.  The small IHC
> logo is all but gone.  Does anyone have a source for these small logo's
> used in the casting process or have any ideas?  My only thot is a CNC
> machine.
> 
>  later,
> RickinMt. 
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel
>