[SEL] Advice needed on Main Bearing mating surfaces

[Richard Strobel]

Yes Tom..or how about some petroleum resistant, say 1/8th inch rubber?

Rick


----- Original Message ----- 
From: <Germoamer at aol.com>
To: <sel at lists.stationary-engine.com>
Sent: Thursday, April 21, 2005 5:58 AM
Subject: Re: [SEL] Advice needed on Main Bearing mating surfaces


> In a message dated 4/20/2005 8:31:35 PM Eastern Daylight Time,
> Richard_Strobel7 at msn.com writes:
>
> << I just might go with soft wood >>
> Rick,
>
> Another consideration is some good gasket material which I have used in 
> the
> past.
>
> Tom Schmutz
> Concord, Va. USA
> Germoamer at aol.com
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel
>