[SEL] Cooper/Stover

[Brock Summerfield]

G,day Ray
make sure when you pull gov weights back make sure that there is a nuff 
travel so that the detent arm latchs in also if you screw the adjust bolt 
down on the
top of the govenor hope that helps
Brock
----- Original Message ----- 
From: "Ray Freeman Portable Line Boring" <plb at iinet.net.au>
To: "The SEL email discussion list" <sel at lists.stationary-engine.com>
Sent: Thursday, April 21, 2005 7:43 PM
Subject: [SEL] Cooper/Stover


After  beginning work on a little Cooper/Stover KA in February it run for 
the first time an hour ago. Just hooked up the fuel and a bit of fiddling 
with the mixture needle it took straight off. I do have a problem with the 
governor. Its not latching the push rod at all. The governor weights are 
free to throw out but they don't push the shaft out to contact the latch 
lever. When stopped everything seems free and feels OK. Anyone got any clues 
as to what's wrong?

Ray Freeman

Portable Line Boring
http://www.plb.iinet.net.au
plb at plb.iinet.net.au
_______________________________________________
SEL mailing list
SEL at lists.stationary-engine.com
http://www.stationary-engine.com/mailman/listinfo/sel