[SEL] Re: Pinned Rings - Problems or Not? now back to nutz

[Luke Tonneberger]

Hey Curt, I sent a message to the list showing an illustration, from an old 
manual, of the nut being installed with the flat against the material being 
fastened. You were in Australia at the time I think. Did you happen to see 
that post?

http://public.fotki.com/deanvp/tractor_plows/jd-1/plow_bolts/oliverboltheads.html

Luke Tonneberger
Rockford, Michigan
USA
=====================

>From: Curt <curt at imc-group.com>
>Reply-To: The SEL email discussion list <sel at lists.stationary-engine.com>
>To: The SEL email discussion list <sel at lists.stationary-engine.com>
>Subject: Re: [SEL] Re: Pinned Rings - Problems or Not? now back to nutz
>Date: Wed, 20 Apr 2005 14:11:44 -0400
>
>Ahh another believer!
>Plus this prevents tearing up the paint too badly when you tighten or 
>remove the nut. Which was _the_ reason I did it.
>Curt
>
>Richard Strobel wrote:
>
>>  Turning the nut over has it's advantages.  As you can see here, William 
>>has made the hole too big <vbg>.
>>
>>http://community.webshots.com/photo/88886243/198576448EpElxc
>>
>>Turning the nut over has centered the eyebolt in the hole and everything 
>>is hunky doory:
>>
>>
>>http://community.webshots.com/photo/198575839/198575839BpwZwt