[SEL] update on Galloway Sawing Outfit

[Richard Strobel]

Ok Thanks Ron.  Got plenty of time to file.  Definetly need to look into a 
tig and possibly a wire welder for other old iron projects.  I could forsee 
a benefit of using a lathe for dressing the tig'd gear teeth also.

c'ya,
RickinMt.


----- Original Message ----- 
From: "Ron Frost, Kersey, PA" <ron217_2000 at yahoo.com>
To: "The SEL email discussion list" <sel at lists.stationary-engine.com>
Sent: Tuesday, April 19, 2005 4:31 AM
Subject: Re: [SEL] update on Galloway Sawing Outfit


> I wouldn't junk it Rick. Take it to a good weld shop and have them tig 
> weld the bad spots. Then with a Dremmel or other small grinder and a good 
> file, bring the teeth back into shape. I did this with a worn gear in an 
> old garden tractor I have and it works fine.
> Ron
>
> Richard Strobel <Richard_Strobel7 at msn.com> wrote:
> Howdy all;
> Well I got the flywheels off today and will head for Missoula in the
> morning to get the crank straightened. I need your opinion. Should I trash
> this crankgear? The other side is ok.
>
> http://community.webshots.com/photo/88886243/325803799INERIg
>
> TIA
> RickinMt.
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel
>
>
>
> Ron Frost
> Kersey, PA
>  http://albums.photo.epson.com/j/AlbumIndex?u=4070123&a=30427007&f=0
>
>   http://community.webshots.com/user/ron15846
>
> " Collector of other peoples cultured merchandise "
>
>
>
>
>
> ---------------------------------
> Do you Yahoo!?
>  Plan great trips with Yahoo! Travel: Now over 17,000 guides!
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel
>