[SEL] update on Galloway Sawing Outfit

[Richard Strobel]

Well Reg, up here we say..you can dress 'em up, just can't take'm out.  In 
this case, I'll dress the ole Gal's gear up and take her out.

That damn wallet does get it the way!!

later,
RickinMt.


----- Original Message ----- 
From: "R & M Ingold" <randmingold at hotkey.net.au>
To: "The SEL email discussion list" <sel at lists.stationary-engine.com>
Sent: Monday, April 18, 2005 8:10 PM
Subject: Re: [SEL] update on Galloway Sawing Outfit


> For the actual load it carries, a file up of the burrs would get it 
> running
> again with no noise.
> A lot depends on the cost of a new one and the cost of the shaft repair in
> relation to your wallet!!
> Reg & Marg Ingold.
> Newcastle, NSW, Australia.
> randmingold at hotkey.net.au
> http://www.oldengine.org/members/randmingold
>
> ----- Original Message ----- 
> From: "Richard Strobel" <Richard_Strobel7 at msn.com>
> To: "sel" <sel at lists.stationary-engine.com>
> Sent: Tuesday, April 19, 2005 11:00 AM
> Subject: [SEL] update on Galloway Sawing Outfit
>
>
> > Howdy all;
> >  Well I got the flywheels off today and will head for Missoula in the
> > morning to get the crank straightened.  I need your opinion.  Should I
> > trash this crankgear?  The other side is ok.
> >
> > http://community.webshots.com/photo/88886243/325803799INERIg
> >
> > TIA
> > RickinMt. _______________________________________________
> > SEL mailing list
> > SEL at lists.stationary-engine.com
> > http://www.stationary-engine.com/mailman/listinfo/sel
>
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel
>