[SEL] update on Galloway Sawing Outfit

[R & M Ingold]

For the actual load it carries, a file up of the burrs would get it running 
again with no noise.
A lot depends on the cost of a new one and the cost of the shaft repair in 
relation to your wallet!!
Reg & Marg Ingold.
Newcastle, NSW, Australia.
randmingold at hotkey.net.au
http://www.oldengine.org/members/randmingold

----- Original Message ----- 
From: "Richard Strobel" <Richard_Strobel7 at msn.com>
To: "sel" <sel at lists.stationary-engine.com>
Sent: Tuesday, April 19, 2005 11:00 AM
Subject: [SEL] update on Galloway Sawing Outfit


> Howdy all;
>  Well I got the flywheels off today and will head for Missoula in the 
> morning to get the crank straightened.  I need your opinion.  Should I 
> trash this crankgear?  The other side is ok.
>
> http://community.webshots.com/photo/88886243/325803799INERIg
>
> TIA
> RickinMt. _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel