[SEL] New Way engine

[SERVICE]

Hi guys, thanks for the input, Peter i have had a look at Bobs and his is on
the governor side and he has a pop rivit in it, his is a 3.1/2hp, so it was
hard to work out exact spot on mine, i have been told that the engines with
breather on the side are later than engines with breather near fuel filler.
Thanks again,
Chester.








----- Original Message ----- 
From: "peter ogborne" <jopeter at omninet.net.au>
To: "The SEL email discussion list" <sel at lists.stationary-engine.com>
Sent: Wednesday, April 06, 2005 7:11 PM
Subject: Re: [SEL] New Way engine


> Chester ....one of the boys up at Midland is going to send me  a pic . I
am
> also going to see Bob  Bailey on Friday morning , i will have a look at
his
> Newway and send you a picture.........might save you getting the iron
> filings as Arnie suggests!
> ----- Original Message ----- 
> From: "Arnie Fero" <fero_ah at city-net.com>
> To: "Stationary Engine List" <sel at lists.stationary-engine.com>
> Sent: Tuesday, April 05, 2005 11:51 PM
> Subject: Re: [SEL] New Way engine
>
>
> > Hi Chester,
> >
> > This is a wild shot...  If you don't get any positive suggestions as to
> > where the hole might be, it's just possible that a Magnaflux technique
> > might work.  I'd recommend looking the process up on the web, but I
think
> > basically you turn your crankcase into an electromagnet and dust it with
> > iron filings.  Normally used to find cracks, but it should also work to
> > find a plastic-filled small hole.  Good luck.  If it works, post the
> > "success story."  If it doesn't, forget I ever said anything.  8-))
> >
> > See ya,  Arnie
> >
> > Arnie Fero
> > Pittsburgh, PA
> > fero_ah at city-net.com
> >
> > On Tue, 5 Apr 2005, SERVICE wrote:
> >
> >> Hi guys, i am currently restoring a vertical new way, it is a 4.5hp
> >> hinged crankcase hit miss, the previous owner started restoring this
and
> >> has filled & painted over the fuel tank breather hole, i am trying to
> >> find either pictures or a diagram of where this hole is located as i am
> >> going to have to redrill it, i belive some engines had the hole on the
> >> governor side & some had it on the front fuel filler side depending on
> >> build date, the hole is approx 1/8 in dia ?.  Appreciate any comments,
> >> thanks.
> >> Chester from West Aussie.
> >
> > _______________________________________________
> > SEL mailing list
> > SEL at lists.stationary-engine.com
> > http://www.stationary-engine.com/mailman/listinfo/sel
> >
> >
>
>
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel