[SEL] Swivel for front bolster on engine truck.

[Dave Otto]

Hi Bill

That may have been my little project, I haven't had time to finish it
yet but I hope to get back to it this fall and winter.

Here is the link, http://community.webshots.com/album/115446387eqvhPY

Dave


Dave Otto
Boise, Idaho



-----Original Message-----
From: sel-bounces at lists.stationary-engine.com
[mailto:sel-bounces at lists.stationary-engine.com] On Behalf Of
BillMil357 at aol.com
Sent: Wednesday, September 29, 2004 6:21 PM
To: sel at lists.stationary-engine.com
Subject: [SEL] Swivel for front bolster on engine truck.

Hey Men;

A few months ago a fellow had a picture of  a swivel he made to use
under the 
bolster on his engine truck, he made a beautiful job on it even put a
finish 
on it with a pneumatic pin chipper which put a finish on it that looked
like 
cast iron, it was beautiful, I want to make one but I can't find the
info., 
does any one happen to know who it was that put the info. on the list?

Thanks,

Bill Miller.
_______________________________________________
SEL mailing list
SEL at lists.stationary-engine.com
http://www.stationary-engine.com/mailman/listinfo/sel