[SEL] Silage Chopper - Need I.D.

[Jim and Diane]

39.7 cm

Jim and Diane Kirkes
Hemet, CA
jd.kirkes at verizon.net
----- Original Message ----- 
From: <paulmaples at sbcglobal.net>
To: "The SEL email discussion list" <sel at lists.stationary-engine.com>
Sent: Tuesday, November 16, 2004 4:22 PM
Subject: [Norton AntiSpam] Re: [SEL] Silage Chopper - Need I.D.


> Steve can you tell me what the diameter of the large flywheel is on the
> Appleton #9 Corn Chopper?
>
> Paul
>
> ----- Original Message ----- 
> From: "Steve Barr" <stevebarr at ameritech.net>
> To: "The SEL email discussion list" <sel at lists.stationary-engine.com>
> Sent: Tuesday, September 28, 2004 6:20 PM
> Subject: Re: [SEL] Silage Chopper - Need I.D.
>
>
> > Paul
> >
> > No idea on he maker yet.  I will have to check several books to see If I
> > can match any casting #'s.
> >
> > I hae an Appleton #9 awaiting some minor wood work.
> > http://www.oldengine.org/members/sbarr/EngineEquip/CornChopper.htm
> >
> > I also picked up the monster...A small 4 roll Appleton Husker Shredder
> > which takes the entire stalk, pops the ear of corn off, drops the ear
onto
> > the rollers which removes the husks, sending the ear up the track intoa
> > wagon...The stalk meanwhile, goes thru the same setup as the chopper and
> > sends it thru a blower into a silo or pile.   I finally had it out to a
> > show to test run it and it needs a little work but is working. Pics:
> >
http://www.oldengine.org/members/sbarr/images/Shows/2004SandwichFair/3/26.JPG
> >
http://www.oldengine.org/members/sbarr/images/Shows/2004SandwichFair/3/27.JPG
> >
http://www.oldengine.org/members/sbarr/images/Shows/2004SandwichFair/3/28.JPG
> >
http://www.oldengine.org/members/sbarr/images/Shows/2004SandwichFair/3/29.JPG
> >
> > They are a neat display, but you need corn stalks to run thru them.
> >
> > Steve
> >
> > --- paulmaples at sbcglobal.net wrote:
> > Hey Gang I acquired this Silage Chopper and need help in identifying it.
> > Take a look at these 11 pictures and let me know if anyone has any idea
> > who the maker is:
> >
> > http://community.webshots.com/album/193008252ojcKpj?340
> >
> > Thanks,
> >
> > Paul
> > _______________________________________________
> > SEL mailing list
> > SEL at lists.stationary-engine.com
> > http://www.stationary-engine.com/mailman/listinfo/sel
> >
>
>
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel
>