[SEL] Rivets

ED edstoller at earthlink.net
Fri Jun 25 16:07:13 PDT 2004


Hi Ron,

Would Sears sell these anvils? I guess it would look like a center punch of
drive pin.

Ed Stoller
New Fairfield, CT


----- Original Message ----- 
From: "Ron Frost, Kersey, PA" <ron217_2000 at yahoo.com>
To: "The SEL email discussion list" <sel at lists.stationary-engine.com>
Sent: Friday, June 25, 2004 6:37 PM
Subject: Re: [SEL] Rivets


> Ed,
> There are anvils available that form the round head. There also is backup
anvils to keep the rivit head shape on the other side.
> Ron
>
> ED <edstoller at earthlink.net> wrote:
> I was replacing the bearing in an idler pulley today and when I went to
rivet it back together I was stumped. How does one form the nice rounded
head on the rivets? I have the rivets that fit the hole but I have never had
a special tool to form the heads. The rivets I have are hollow.
>
> Ed Stoller
> New Fairfield, CT
>
>
>
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel
>
>
>
> Ron Frost
> Kersey, PA
>  http://albums.photo.epson.com/j/AlbumIndex?u=4070123&a=30427007&f=0
>
>   http://community.webshots.com/user/ron15846
>
> " Collector of other peoples cultured merchandise "
>
>
>
>
> ---------------------------------
> Do you Yahoo!?
> New and Improved Yahoo! Mail - Send 10MB messages!
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel





More information about the sel mailing list