[SEL] R&V question

[Harry Terpstra]

Hi dwight,
Thanks for the information, my guess it would be a 1" pipe, but it turns out
it's even 1¼".
I plan to make a wooden patern first, we'll see how it turns out;-)

TTYL,

Harry Terpstra
Sint Annaparochie
Netherlands
h.terpstra at wxs.nl
http://home01.wxs.nl/~terps027/home.html



----- Original Message -----
From: <Vivas1993 at aol.com>
To: <sel at lists.stationary-engine.com>
Sent: Friday, December 10, 2004 5:52 PM
Subject: Re: [SEL] R&V question


> Hi Harry,
>  Went out an measured my 6hp R&V, the mixer is threaded for an 11/4" pipe.
> Good luck getting the carb. cast !
>
>  Dwight Vivas
>  Matoaca, VA.
> _______________________________________________
> SEL mailing list
> SEL at lists.stationary-engine.com
> http://www.stationary-engine.com/mailman/listinfo/sel